Mounting the drive, Mechanical outline, Mechanical outline mounting the drive – Applied Motion ST10-C-CE User Manual
Page 49
49
ST5/10-Si,-Q,-C, IP Hardware manual
920-0004 Rev. F
6/10/14
Mechanical Outline
Mounting the Drive
You can mount your drive on the wide or the narrow side of the chassis using #6 screws. If possible, the
drive should be securely fastened to a smooth, flat metal surface that will help conduct heat away from the
chassis. If this is not possible, then forced airflow from a fan may be required to prevent the drive from
overheating.
• Never use your drive in a space where there is no air flow or where other devices cause
the surrounding air to be more than 40°C.
• Never put the drive where it can get wet or where metal or other electrically conductive
particles can get on the circuitry.
• Always provide air flow around the drive. When mouting multiple ST drives near each
other, maintain at least one half inch of space between drives.
3.0
1.775
5.0
6X SLOT 0.16
WIDE, FULL R
0.663
1.98
0.61
4.74