Mating connectors and accessories – Applied Motion ST10-C-CE User Manual
Page 51
51
ST5/10-Si,-Q,-C, IP Hardware manual
920-0004 Rev. F
6/10/14
Mating Connectors and Accessories
Mating Connectors
Motor/power supply: PCD P/N ELV06100, included with drive.
IN/OUT1: DB-25 male. AMP P/N 5-747912-2. Shell Kit AMP P/N 5-748678-3. Included.
Optional encoder feedback: HD-15 male. Norcomp P/N 180-015-102-001. Shell Kit AMP P/N 5-748678-
1. Not included.
Accessories
Breakout Box for DB-25 Connector
BOB-1, includes cable
Screw Terminal Connectors that mate directly to the DB-25 connector on the front panel of the drive:
Phoenix Contact P/N
This connector is not available from Applied Motion. You must purchase it from a
Mating Cable for IN/OUT connector with “flying leads”
Black Box P/N: BC00702
This cable is not available from Applied Motion. You must purchase it from
Useful for custom wired applications. This shielded cable has a DB-25 connector on each
end. You can cut off the female end to create a 6 foot “DB-25 to flying lead cable”.
It’ll be easier to wire if you get the
Regeneration Clamp:
Applied Motion Products
.
Power supplies:
Applied Motion Products PS320A48 (48 VDC, 6.7A)
Applied Motion Products PS150A24 (24 VDC, 6.3A)
Applied Motion Products PS50A24 (24 VDC, 2.1A)
Operator Terminal (-Si drives only)
Applied Motion Products MMI-01 or MMI-02 (backlit).
Recommended CANopen USB Adapter (-C drives only)
This adapter is not available from Applied Motion Products