Dynex OPSYS MW 91000051 - Manual (Page 59)

Creating a New Wash Protocol
To specify a Soak (within a Move):
Note: A Soak can be performed either within
or outside of a Move cycle. The procedure
below describes the procedure for specifying a
soak within a Move cycle.
The procedure for specifying a Soak outside
of a Move cycle is described on page 50.
1. Scroll right to display the next selection. The display will read:
Select option
SOAK FILL
2. Select SOAK. The display will read:
Duration? 5
3. Enter the desired soak duration using the keypad.
Note: A soak duration ranging from 1 to 999
seconds can be entered.
4. Press ENTER The display will read:
Select option
SOAK FILL
Opsys MW™ User’s Guide 51