Doremi ShowVault / IMB - Manual (Page 6)

CRT.OM.001087.DRM Page 6 Version 1.7
Doremi Labs
1 Introduction
1.1 Introduction
This document explains how to install the IMB into a Barco Series-2 projector. This document
also describes the steps required to perform the “marriage” between the IMB SM and the
projector electronics. Marriage is the process of engaging the DCI physical and software
interlocks that enable the display of secured materials.
The IMB requires a Doremi ShowVault server in order to work. This document also explains how
to set up and connect the ShowVault server to the IMB board.
1.2 Purpose
One of the key ideas behind marriage is that an authority figure examines the projector and
ensures that it has not been tampered with before a marriage can be performed. This means
that a person must be physically at the projector when the marriage is performed. It cannot be
done remotely. To ensure an authority figure is present, there is a physical marriage button (or
RFID key) on the projector which must be pressed in order for the marriage process to
complete. Please contact your system administrator or Barco Technical Support for the required
passwords.
1.3 Software Version

This manual is intended for software version 2.0.10 and higher.

This document is to be used with IMB SM 5.0.5 and higher.

It is also to be used on Barco projector software version 1.3.41 or higher with TI (ICP)
firmware 2.2.294 or higher.
1.4 Contact
If in need of help or assistance, please contact Doremi Labs Technical Services:
USA
24/7 Technical Services line: +
1-866-484-4004
Technical Services Email: [email protected]
Europe
24/7 Technical Services line: + 33 (0) 492-952-847
Technical Services Link:
http://support.doremitechno.org/ticketing
Japan
Technical Services line: + 044-966-4855
Technical Services Email:
[email protected]
Australia ~ China ~ India ~ Indonesia ~ Korea ~ Malaysia ~ New Zealand ~ Philippines ~
Singapore ~ Taiwan ~ Thailand
Technical Services Email:
[email protected]