Doremi GHX-10 User Manual
Page 23
•
Last step
: Wait for the driver installation to be completed. Click on the “Finish” button
when done.
Figure 7: ”Found New Hardware Wizard” Window – Last Step
•
Run the Doremi Universal Interface GUI and verify that you have a proper connection by
looking at the “Devices” tab which should show the Model and Serial numbers.
Note: If you get the following message during the installation:
Figure 8: Hardware Installation Warning Window
•
Click on the “Continue Anyway” button.
Note: If during the automatic installation you get a message asking you to search for a specific
file,
•
Hit cancel then uninstall duis.
•
While the GHX-10 unit is still connected, go to the Device Manager > Universal Serial
Bus Controllers and uninstall Doremi GhX Board.
•
Install duis again and recycle power on the GHX-10 which should take you back to Step
1 or Step 2 above.
GHX.OM.000510.DRM
Page 23
Version 2.2
Doremi Labs