NeoPro Borrego+ 8x8 - Manual (Page 11)

11
DOC42-00027-B Integrator's Guide.doc
Fig. 3
The IR INPUT indicates the location of the IR sensor.
The ACTIVITY LED blinks when a command was received in serial, whether
valid or not. It also blinks for every valid IR pulse received by the sensor.
IR Remote Control
Figure 4 shows the layout of the NeoPro IR Remote. Controlling the matrix
switch via the rear IR jack is the same as using the NeoPro IR Remote.
Discrete IR Codes
Discrete IR Codes allow you to minimize IR codes sent from program macros
when doing switching and volume commands. There are discrete codes for
volume up, down, and mute for each output. To use the discrete codes, first send
the IN# then the OUT#, or the single IR code for each volume function desired.
Discrete codes for switching are limited to switching all levels at the same time.
For further information on programming of remotes and control systems, you
may download the discrete IR codes (HEX format) from our website:
http://www.neoprointegrator.com