NeoPro Borrego+ 8x8 - Manual (Page 9)

9
DOC42-00027-B Integrator's Guide.doc
Connector Labels Signal type(s)
Y, Pb, Pr
High definition component video inputs and
outputs
L, R
Analog audio, stereo Left & Right inputs and
outputs
D, Vid
Composite video or SPDIF digital audio inputs
and outputs
Optical Digital Audio
Inputs
Digital Audio inputs via optical cable (TOSLINK)
Spdif Digital Audio
Inputs
Digital Audio inputs via RCA cable (SPDIF)
Digital Audio
Outputs
Digital Audio outputs via optical and RCA cables
Pass-Through
Outputs Used for stacking another NeoPro matrix switch to
increase output zones
IR
Input for unmodulated IR control signal via
3.5mm 2 conductor plug (tip = signal)*
RS232 Serial port for control
USB
USB port for control. Software is provided to setup
USB as a virtual serial port. See the Serial
Protocol and USB Driver Installation section of
this manual
AC 90-240VAC
AC power input (50-60Hz) via IEC320 appliance
inlet. Connect last, after all I/O cables
*Some IR repeater systems are designed to work only with their own IR
blasters, and a common “workaround” is to cut these blaster cables and add a
3.5mm plug on the end. In some cases, repeater systems will have noise that
prevents signals from being decoded.
Notes on I/O Signals
HD Video Quality & Cable Length
On Coax/RCA output models, the maximum length of cable to each zone will
vary on the quality of the cable. High quality quad-shielded RG6 cables can
support zones 300 feet away.
For Cat5 output models, standard Cat5 or Cat5e is preferred for runs up to 1,000
feet.
RS-232 Details
The serial port is wired as a DCE device, and should be connected to a
computer’s RS-232 port with a straight through cable. Connection to most