TabletKiosk eo TufTab a7230X - Manual (Page 25)

10 Chapter 01: Getting Started
Touch Screen mode
Navigating with a touch screen is different from navigating with
a mouse. The pen will interact with the computer whenever you
touch it to the screen.
Hold the stylus pen as if you were writing with a standard pen.
Instead of sliding the pen around the screen, just tap on what
you want to interact with. Sliding the pen while lightly touching
the tip to the screen will move the on-screen pointer around as
if you were using a mouse and holding down the left mouse
button. In other words, you would be performing what is known
as a drag operation.
Also, remember that since the screen is sensitive to the touch,
resting your hand on the screen while using the pen might make
the pointer react unpredictably.
TIP: When trying to select or activate something on the screen with
the stylus pen, pay attention to the position of the pointer icon instead
of the tip of the pen.
Tapping lightly on the screen will perform a standard left mouse
button click. Holding the tip of the pen against the screen with-
out moving it for about a second or so will perform a standard
right mouse button click.
Active Digitizer mode (a7230XD only)
The eo TufTab a7230XD dual mode screen is auto-sensing. The
screen will default to touch screen mode until is senses that the
writing tip of the stylus pen is near the screen. Once the pen
is close enough to the screen to be detected, the eo TufTab
a7230XD will automatically switch to digitizer mode.
Hold the stylus pen as if you were writing with a standard pen.
Place the tip of the stylus just above the screen and move it
around. The pointer should follow the tip of the pen. In this
mode your hand may rest on the screen, since this will not affect
the behavior of the pointer.