WaveWare Enterprise - Manual (Page 22)

Configure Options – Paging Services Tab
In this Tab, you would enter the Paging Service’s Information for use with City/Nation Wide Model Pagers.
This Information will be Provided by the Paging Service Company. To enter the Paging Services Information,
Click on the “Add” Button. Note that SNPP protocol is used to communicate to the paging services.
An Example Configuration is shown on the Screen below.
After entering the Configuration Information, click the “Test” Button to Test the Connection.
Type a Message and a Pager PIN Number and Click OK to send a Test Message to a Pager.
It may take a few Minutes to Receive the Test Message from the Provider Service’s Tower.
If the Test Fails, check that the Configuration and Information from the Provider is correct.
Next: Configure Options – SMTP Mail Server
22