Xtramus DApps-MPT V1.4 - Manual (Page 56)

56
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®
D & F. Selected Tasks
All tasks you’ve selected from Built-in Tasks field will be listed in the Select
Tasks. The number of the tasks you chose will be shown here as well.
To remove a task from Selected Tasks, please click the task you would like
remove here, and click button.
E. Selected Tasks Managing Buttons
You can manage the testing order of tasks listed in the Selected Tasks.
To move the priority of a task listed in Selected Tasks up, click on that task, and click
button; to move the priority of a task listed in Selected Tasks down, click on that task, and
click button.
If you would like to remove all the tasks listed in Selected Tasks, click button.
After choosing the tasks you would like to perform from B. Built-in Tasks, you can start making detail
settings with individual tasks by clicking the task you would like to configure from List of Selected Tasks.
All the configurations for this task will be listed in the right-side section as shown in the figure down below.
Please note that the maximum number of tasks that can be selected into the List of Selected Tasks is
32.
As mentioned in “8.2. Task List Settings, B. Built-in Tasks & C. Task Group Selection”, all tasks
available for DApps-MPT can be divided into different groups Layer 1, Layer 2, Layer 3, Serial Port,
and others (General).
For more detailed information regarding to task settings in DApps-
MPT’s task groups, please refer to “5.
DApps-MPT Detail Task Setting
.”
Click the OK button on the bottom-right side of Option – New Model window when all configurations are
done. A “Save As” window will pop up and prompt you to save all the configurations you made.