Xtramus NuApps-IGMP-RM V1.2 - Manual (Page 13)

Please follow the steps down below to starts NuApps-IGMP-RM and NuServer properly.
Starting NuServer / NuApps-IGMP-RM
When starting NuApps-IGMP-RM, a “Connect to
NuServer” window will pop up and asked how you are
going to connect to NuServer.
¾ Local Host: Choose this option when you’re
running NuApps-IGMP-RM from NuStreams-2000i
IPC module or a PC that’s connected to
NuStreams-2000i/600i via an RJ45 cable.
¾ Remote: Choose this option when you’re running
NuApps-IGMP-RM from other PC located on the
network. Choose the IP address which is assigned
from NuStreams-2000i/600i from the scroll-down
menu, or choose demo to enter
NuApps-IGMP-RM’s Demo Mode.
¾ Connect/Cancel: Click the Connect/Cancel button
to connect to NuStreams-2000i/600i or cancel
starting NuApps-IGMP-RM.
A “NuServer-NIC Information” window will pop up. Please select the NIC (Network Interface Card) which
is connected to NuStreams -2000i/ 600i’s from the Network Interface Information table, and click OK. If
you’re using NuStreams-2000i’s IPC module, please choose “Realtek RTL8139 Family Fast Ethernet”.
13
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®