Xtramus NuApps-IGMP-RM V1.2 - Manual (Page 45)

5.5. Group Capacity Test
The objective of this test mode is to determine the maximum number of multicast groups that a device or
system under test (DUT or SUT) can support while maintaining the ability to forward multicast frames to
all multicast groups registered to that DUT/SUT.
One or more destination test ports of DUT/SUT will join an initial number of multicast groups. After a
minimum delay, the source test ports must transmit to each group at a specified provided load. If at least
one frame for each multicast group is forwarded properly by the DUT/SUT on each participating egress
interface, the iteration is said to pass at he current capacity.
Port setting
Source Pair You can choose the previous set Test Pair to be used on the Latency test.
Last Pass Group Capacity
Shows the current pass group capacity of this test.
45
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®