AMETEK XBT Series - Manual (Page 17)

2.
INSTALLATION AND
MAINTENANCE
This section describes installation and maintenance requirements.
2.1 Initial Inspection
Remove device from packaging; inspect for any physical damage incurred during
shipment; report any such damage to the carrier.
2.2 Conditions of Use
• Operate indoors only.
• Refer to Section 1.3, Specifications, of this manual.
• Select the correct voltage setting (see Section 2.3, Power-Line Voltage).
• Ensure that the operating environment power supply is free of dust, vibration,
direct sunlight and corrosive gas.
• Ensure clearance of at least 10 cm for adequate ventilation.
• Install a power filter if noise from the AC power source is inevitable.
• Calibrate annually.
M370187-01
Rev J
2-1