AMETEK XBT Series - Manual (Page 38)

Remote Interface Protocol and Package Mode
complete before executing commands following the *WAI command.
Examples:
How to save V/I to memory:
*SAV 15 ==> Saves current settings to memory number 15
SAV 0 ==> Saves current settings to memory number 0
How to recall memory V/I variable to output:
*RCL 3 ==> recall setting from memory location 3
RCL 120 ==> the data value is invaild
How to save configuration parameters:
SAV
*SAV
How to do the software reset procedure:
*RST
RST
How to return the device identification:
*IDN?
IDN?
SCPI Command for Subsystem
OUT[n] on/off subsystem for channel n: 1 - 3
[ state/bool] ON/1 (enable) or OFF/0 (disable) output action
:ALL[ state/bool] ON/1 (enable) or OFF/0 (disable) output action
for all channels
:TRACK enable track mode
:PARAllel enable parallel mode
:SERial enable serial mode
:NORMal resume normal mode
STATus status subsystem
[?] read back machine status
5-4
M370187-01 Rev J