AMETEK XBT Series - Manual (Page 46)

Remote Interface Protocol and Package Mode
How to read back serial number:
MEM:SERIAL?
MEMORY:SER?
How to modify machine ID (address):
CONTROL:ADDR 23 ==> modify id to 23
CONT:ADDRESS 09 ==> modify id to 9
How to check password:
CONT:PASSWORD 123456 ==> enter password to verify
How to enter or leave the monitor mode (not supported over GPIB or Ethernet LAN):
CONT:MONITOR ON ==> enter the monitor mode
CONTROL:MONI OFF ==> exit the monitor mode
How to change channel:
CONT:CHANNEL 1 ==> change to channel 1
CONT:CH 1 ==> change to channel 1
CONTROL:CH 2 ==> change to channel 2
How to enter or leave lock status:
CONT:LOCK ON ==> enter lock mode
CONTROL:LOCK OFF ==> exit lock mode
How to enter or leave hotkey status:
CONT:HOTK ON ==> enter hotkey mode
CONTROL:HOTKEY OFF ==> exit hotkey mode
How to measure current:
MEASURE:CURR1? ==> read back current 1 result
MEAS:CURRENT3? ==> read back current 3 result
MEAS:CURR3? ==> read back current 3 result
CURR1? ==> read back current 1 result
CURRENT2? ==> read back current 2 result
5-12
M370187-01 Rev J