Table 2-10, Software installation and configuration – Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) User Manual

Page 34

Advertising

Software Installation and Configuration

System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C)

Make sure that the net-snmp 5.1.2 or higher package as well as the HPI-B client base package
are installed on the ATCA-MF106/SAM1411 where you wish to install the SNMP agent. In order
to install the SNMP subagent package, proceed as follows:

Connect to the ATCA-MF106/SAM1411 blade where you wish to install the HPI-B SNMP
subagent package.

Copy the package file to the ATCA-MF106/SAM1411.

If applicable, enter rpm -e <Old HPI-B SNMP subagent package name> to
uninstall an existing SNMP subagent package

Enter rpm -i <New HPI-B SNMP subagent package name> to install the new
package.

After the installation of all required packages, the SNMP agent related files can be found in the
following directories on the ATCA-MF106/SAM1411:

net-snmp 5.1.2 or higher

This is an open source suite which contains files needed by
the SNMP master agent as well as useful SNMP command line
tools. It is part of the ATCA-MF106/SAM1411 BBS software
and therefore there should be no need to install it manually.

HPI-B client package

Since the SNMP subagent is an HPI-B client application, it
relies on the HPI-B client package to be installed. For details
about how to install and configure an HPI-B client package,
refer to

Setting Up HPI Clients

on page 28

Table 2-10 Overview of SNMP Agent Related Directories and Files on ATCA-MF106/SAM1411