Setup maintenance, Weld by time, Saving the current setup – Dukane Ultrasonic Hand Held System iQ Series User Manual

Page 37: Selecting a setup, Deleting a setup

Advertising
background image

Page  31

Section 5 - Process Control Settings

Dukane Manual Part No. 403-577-01

Setup Maintenance

Continued

Saving the Current Setup

Try using your navigation skills on this example:
1. Follow instructions on Page 24 to set the mode to

Weld by Time. Set the time to 1.520 seconds.

See Figure 5-23.

2. Press SETUP and then press the

+

key until you

get an Empty Setup Maintenance screen.

See Figure 5-24.

3. Use the right arrow key to select Store, and then

press ENTER. You will be returned to the Operate
screen.

4. Confirm that your setup has been stored in memory

by going back to SETUP. Your new setup should
appear, just as it does in Figure 5-25.

Selecting a Setup

To select a setup previously stored:

1. Press SETUP.

2. With Load highlighted, use the keys to select

the number of the setup you want.

3. Press ENTER.

4. The Operate screen will display this selection as a

number in the lower left hand corner.

Deleting a Setup

To delete a setup previously stored:

1. Press SETUP.

2. With Delete highlighted, use the keys to select

the number of the setup you want.

3. Press ENTER, and a pop-up screen will ask you to

confirm your selection. Make your choice, and press
ENTER.

4. Check that the setup is deleted. Press SETUP, and the

Setup Maintenance screen will show EMPTY for the
setup you just deleted.

Figure 5-23 Save Current Setup

Figure 5-24 Store in Setup Maintenance

Figure 5-25 New Setup Stored

Setup Maintenance

Load

Store

Setup #

1

T: 1.520 S A: 100%

Mode: Manual

E: 0 J H: 0.0 S

Delete

Weld by Time

Press Enter To Accept
Press Cancel To Abort

Weld Time

1.520 S

Setup Maintenance

Load

Store

Setup #

1

EMPTY

Delete

+ -

+ -

Advertising