Beisler 100-58 - Manual (Page 18)

1-16
5. Press F6 repeatedly, until the interface appears above the working plate.
6. Mount the insertion plate; be sure that the positioning pins are inserted
into the drill holes.
4.1.10 Empty the stacker
Press the foot pedal of the stacker, if it is full. The stacker will open and you
can remove the parts. Release the foot pedal to close the stacker.
4.2 Operation
4.2.1 Machine sequence
The production sequence is divided into several parts:
1. Machine sequence can start, if the machine is in starting position.
2. Insert the parts to be sewed and align them exactly.
3. Press the foot pedal machine sequence and the clamp comes forward.
4. Press the foot pedal again, the clamp will be lowered.
5. Press foot pedal, the folder is lowered and the fold pushers are driven to
the front.
6. Press foot pedal, the flap clamp closes.
7. Press foot pedal, the clamp pushes the part under the sewing head, it will
be sewed there, the mitres will be cut, the clamp opens and the sewed
part will be stacked.
The operator can trigger each step with a short pressing of the foot pedal, or
run an automatic process by keeping the foot pedal pressed.
Depending on the programming, different machine sequences might occur.
4.2.2 Program operation
The machine is operated with programs, which can be selected by the
operator. A program is stored at a memory location (e.g. ‘M01’) and contains
one or several seams (max. number is six).
The selected program and the assigned seams are imaged in the upper line
of the display. The machine executes all enabled seams of a program
sequentially. An enabled seam is displayed inverted (white on black).
You can produce several pocket shapes and lengths sequentially, without
changing the sewing program. This allows to sew several pockets of a jacket
part.
The following operational actions are explained in this chapter:
• select a sewing program
• enable/disable seams
• change seam lengths
• change sewing programs
• create new sewing programs
• program new seams
4.2.3 Select a sewing program
The current sewing program is displayed in the upper line of the display. How
to select a program:
1. Press M-key.
2. Enter the number of the desired program using the ten key pad.
3. Press ENT-key.