Beisler 100-58 - Manual (Page 40)

2-20
Error 28: No impulses
from sewing engine no impulses from sewing engine
after sewing start (engine doesn’t
work) check sewing engine and synchronizationcheck
connection 9020013 > sewing engineread two
upper diodes at 9020013: left lights shortly if
needle in top position; right shows synchronizator
impulses (512 impulses per turn); if none lights
while turning the hand wheel, check power
supply; possibly change sewing engine
if diodes are working and engine doesn’t move
before error message, check connection 9020020
> sewing engine; possibly change 9020020 or
engineif engine works shortly before error messa-
ge, check connection controls > I/O module;
possibly change components
Error 29: Sewing engine
too fast during thread cutting the sewing
enginge couldn’t reach cutting
speed within error time change sewing engine or synchronizator
Error 30: Thread cutter
position doesn’t come the sewing engine hasn’t reached
the position for thread cutting set a slower cutting speedset an earlier cutting
positionchange sewing engine or synchronizator
Error 33: Sewing engine
doesn’t stop engine doesn’t stop within error
time after thread cutting set a slower cutting speed; set an earlier cutting
position; change sewing engine or synchronizator
Error 34: Needle not up needle couldn’t reach the top
position; with the error message the
control tries to put the needle into
the top position again check sewing engine and synchronizator; check
connection 9020013 > sewing engine; read two
upper diodes at 9020013: left lights shortly if
needle in top position; right shows synchronizator
impulses (512 impulses per turn); if none lights
while turning the hand wheel, check power supply;
possibly change sewing engine
if diodes are working and engine doesn’t move
before error message, check connection 9020020
> sewing engine; possibly change 9020020 or
engine
Error 35: Thread broken threat monitor detects breakage
Error 36: Spool empty mode ‘Bottom thread counter’
enabled; remaining length is zero
Error 37: Spool only
residual one of the photo cells at the spool
capsule is lighted, the spool is
empty if both spools are not empty, one photo cell
reflects the thread and must be set smaller
Error 41: No flap automatic flap legth detection with
phot cell is enabled but no flap is
detected insert flapcheck photo cell ES31 and film
Error 42: Photo cell not
lighted automatic flap length detection with
photo cell enabled; no flap within
the security length detected program a longer security lengthswitch off super-
vision (enter 250 mm as seam length)check photo
cell ES31 and film
Error 43: Photo cell
lighted too early automatic flap length detection with
photo cell enabled; photo cell
detected flap end too early program a shorter security lengthswitch off
supervision (enter 250 mm as seam length);
check photo cell ES31 and filmset photo cell
sensitivity smaller (reflections?)
Error 45 ... 48: I/O
DACI/O ULNI/O 485I/O
RES internal hardware errors during data
transfer to adaption board 9020020 change 9020020
Error 51: Flap station
doesn’t swing flap station couldn’t reach the active
position within error time check cylinder, gauge Y17, termination switch
ES08
Continuation: see bottom of left-handed side