Beisler 1500-70-2 User Manual
Page 35
2-11
SETUP-03
SOFT
START
(>>>) : 3
a: 900
[ms]: 70 : 400
The switch on delay and duration of the thread cutter are programmed here.
You should enter 70 ms as switch on delay and 400 ms as active duration.
Program three stitches with 900 revs in the page section „Soft Start“.
Press the Special key to close the page.
3.5.2
After thread cutting, time until sewing foot up
SETUP-03
0
400
600
There is no possibility in the thread cutting mode of programming the time
until the sewing foot is lifted after cutting the thread. As an alternative, the
function „Thread wiper“ is used.
On setup page -10, output F4 must be disabled. The thread wiper must be
enabled on setup page -03. Then you can program the times like shown in
the drawing.
3.5.3
Presser foot
(max)
30V
15 V
120
00
150
[ms]
SETUP-02
1. Position the cursor on the time of maximum power (left value in lower row)