Beisler 1500-70-2 - Manual (Page 37)

2-13
KP speed factor in puller mode (1 ... 15): speed factor for the synchronous
operation (1 ... 7 = half step; 8 ... 15 = full step);
KA acceleration curve;
IL holding voltage in home position (1 ... 15): this should reduced to a
minimum for both motors to avoid over heating;
IH working voltage (1 ... 15): here you have to consider the
manufacturer’s information; if the working voltage is set too high, the
motors will be destroyed.
ATTENTION
Damage to the motors due to inadequate settings! Before you modify one of
the values shown here (especially value IH), you should contact the Beisler
service staff.
3.5.6 Tape transportation
At the end of the sewing program, the liner tape will be inserted under the
sewing foot automatically that the next sewing process can start immediately.
The tape transportation distance is programmed in a way that the liner tape is
grasped by the needles at seam start.
To modify the transportation distance, you will first have to select the sewing
program, where you want to modify this distance. Move the cursor on „STEP
01“ and press the Plus key repeatedly, until the last step in the program is
displayed (here: STEP 09):
Fn
STOP
T: 300
9
09
STEP
001
PROG.
P1
P2
Position the cursor on the motor icon (bottom row, second icon from the right)
and press the Special key. This page will be displayed:
1 2 3 4
MOD.
ROT.
VAL. POS.
105
PUL.
0
STEP
009
Position the cursor on the value „105“ and modify it by pressing the Plus/
Minus key repeatedly.
Press the Special key to leave the page. Position the cursor on „PROG“ and
press the Plus key. The machine is ready for sewing.
3.6 Setup page -10