Cloud Electronics CX462 - Manual (Page 10)

CX462 Audio System Controller Setup And Installation Guide
CLOUD ELECTRONICS LIMITED
4 V3 280904
The RSL-6A and RL-1A are available for the American market. They have identical operation
to the RSL-6 and RL-1 but have been designed to fit a single gang US electrical outlet box.
Front panel dimensions are 4½” x 2¾”.
When setting the jumper(s) please ensure that you:
M Remove the mains cable from the rear of the product before removing the top
panel.
M Only reassemble the unit using screws identical to the original parts.
5.3 Music Equalisation
Front panel pre-set controls for treble and bass equalisation of the music signals are provided
in order to allow the installer to tailor the response of the music signals to suit the acoustics
and speaker’s response. The equalisation controls can be concealed behind the removable
plate secured to the front panel with hex key screws; to gain access to the equalisation
controls use the supplied hex key. The equalisation controls are located to the left of the
music source and level controls; they are clearly marked ‘HF’ (High Frequency) and ‘LF’ (Low
Frequency). A flat frequency response can be achieved by positioning the slots on the
control shafts in the vertical plane; the HF control has a range of ±10dB at 10kHz and the LF
control has a range of ±10dB at 50Hz.
5.4 Line 6 Priority
The line 6 music input can be given priority over other music signals. This is intended for use
with sources such as jukeboxes or spot announcement players. This priority is triggered
when a signal is detected on the line 6 input, at which point the selected music source will
mute and the line 6 signal is routed to the output. Once the signal on line 6 ceases, the
selected music source will smoothly restore to its former level. The time taken for this
restoration can be 3, 6 or 12 seconds dependant on how internal jumper J12 has been set;
the factory default restoration time is 3 seconds. In order to switch priority on or off, the
internal jumper J11 can be set, both jumpers a and b will need to be set in the same position.
When setting the jumper(s) please ensure that you:
M Remove the mains cable from the rear of the product before removing the top
panel.
M Only reassemble the unit using screws identical to the original parts.
Music Control continued
Remote control enabling
jumpers
J9: Music source
J10: Music level
Location of Jumpers J9 & J10