Comtech EF Data RCS11 - Manual (Page 105)

MN-RCS11 – Revision 9 C–1
Appendix C. Terminal
Communications
The RCS11 support Terminal communications. If the RCS11 is connected to a terminal (using a
null modem cable) upon power up you should receive the following text:
If the RCS11 is connected to a terminal (using a null modem cable) upon power up you should
receive the following text:
RCS11 1:1 Redundancy Switch
Copyright (c) 1996, 1997
Radyne
At the terminal screen you will receive a prompt: >_
Typing “help” and pressing <Enter> will cause the RCS11 to output a list of queries and
commands
>help
ADDR[<=nn>|<?>]
BAUD[<=nn>|<?>]
DELAYDF[<nnnn>|<?>]
DELAYDN[<nnnn>|<?>]
DELAYMF[<nnnn>|<?>]
DELAYMN[<nnnn>|<?>]
DMD[<=A>|<=B>|<?>]
HELP
MOD[<=A>|<=B>|<?>]
MODE[<=AUTO>|<=MANUAL>|<?>]
STATUS
VER
>
Typing a command followed by a question mark will cause the RCS11 to output its current setting
>addr?
ADDR=32
>
>baud?