Comtech EF Data RCS11 - Manual (Page 42)

RCS11 1:1 Redundancy Switch Installation
MN-RCS11 – Revision 9 4–4
WARNING
PROPER GROUNDING PROTECTION: During installation and setup, the
user must ensure that the unit is properly grounded. The equipment
shall be connected to the protective earth connection through the end
use protective earth protection.
In addition, the IF input and output coax cable shielding must be properly
terminated to the Chassis/unit ground
4.6 Connections
This section provides data and frequency connections in a typical one for one installation.
4.6.1 DMD15 Universal
Figure 4-1 illustrates a 1:1 system using a RCS11 with the Universal Interface connected to
DMD15 Modems. Table 4-1 describes the connection hardware required.
Figure 4-1. RCS11 with Universal Interface Connected To DMD15 Modems