Comtech EF Data SDM-9000 - Manual (Page 225)

SDM-9000 Satellite Modem Remote Control Operation
Rev. 4 B–7
Interface
Buffer
Center Command:
Response: <add/IBC_'cr'
>add/IBC_'cr''lf']
Receive
Clock
Phase Command:
Response:
Status:
Response:
<add/RCP_xxx'cr'
>add/RCP_xxx'cr''lf']
<add/RCP_'cr'
>add/RCP_xxx'cr''lf']
Where: xxxx = NRM (normal clock phasing) or INV (inverted
clock phasing).
Baseband
Loopback Command:
Response:
Status:
Response:
<add/BBL_xxx'cr'
>add/BBL_xxx'cr''lf']
<add/BBL_'cr'
>add/BBL_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Loopback Command:
Response:
Status:
Response:
<add/ILB_xxx'cr'
>add/ILB_xxx'cr''lf']
<add/ILB_'cr'
>add/ILB_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Loop
Timing Command:
Response:
Status:
Response:
<add/ILT_xxx'cr'
>add/ILT_xxx'cr''lf']
<add/ILT_'cr'
>add/ILT_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface
Coding
Format
Transmit Command:
Response:
Status:
Response:
<add/ICFT_xxxx'cr'
>add/ICFT_xxxx'cr''lf']
<add/ICFT_'cr'
>add/ICFT_xxxx'cr''lf']
Where: xxxx = AMI, B3ZS, or HDB3.
Interface
Coding
Format
Receive Command:
Response:
Status:
Response:
<add/ICFR_xxxx'cr'
>add/ICFR_xxxx'cr''lf']
<add/ICFR_'cr'
>add/ICFR_xxxx'cr''lf']
Where: xxxx = AMI, B3ZS, or HDB3.
Scrambler
Enable Command:
Response:
Status:
Response:
<add/SE_xxx'cr'
>add/SE_xxx'cr''lf']
<add/SE_'cr'
>add/SE_xxx'cr''lf']
Where: xxx = ON or OFF.
Descramble
r Enable Command:
Response:
Status:
Response:
<add/DE_xxx'cr'
>add/DE_xxx'cr''lf']
<add/DE_'cr'
>add/DE_xxx'cr''lf']
Where: xxx = ON or OFF.
Transmit
Data Fault Command:
Response:
Status:
Response:
<add/TDF_xxxx'cr'
>add/TDF_xxxx'cr''lf']
<add/TDF_'cr'
>add/TDF_xxxx'cr''lf']
Where: xxxx = NONE, DATA, or AIS.
Receive
Data Fault Command:
Response:
Status:
Response:
<add/RDF_xxxx'cr'
>add/RDF_xxxx'cr''lf']
<add/RDF_'cr'
>add/RDF_xxxx'cr''lf']
Where: xxxx = NONE, DATA, or AIS.