DFI EL330-DR - Manual (Page 15)

15
2
Hardware Installation
1
The system board supports 240-pin DDR3 DIMM sockets. The four
DDR3 DIMM sockets on the system board are divided into 2 chan-
nels:
Channel A - DIMM 1 and DIMM 2
Channel B - DIMM 3 and DIMM 4
DIMM 1
DIMM 2
DIMM 3
DIMM 4
Channel A
Channel B
Warning:
Electrostatic discharge (ESD) can damage your system board, proces-
sor, disk drives, add-in boards, and other components. Perform the
upgrade instruction procedures described at an ESD workstation only.
If such a station is not available, you can provide some ESD protec-
tion by wearing an antistatic wrist strap and attaching it to a metal
part of the system chassis. If a wrist strap is unavailable, establish
and maintain contact with the system chassis throughout any proce-
dures requiring ESD protection.
System Memory
Warning:
When the Standby Power LED lit red, it indicates that there is power
on the system board. Power-off the PC then unplug the power cord
prior to installing any devices. Failure to do so will cause severe
damage to the motherboard and components.
. .
. .
.
.
.
.
. .
. . .
.
.
.
Standby
Power LED