DFI EL330-DR - Manual (Page 43)

43
2
Hardware Installation
1
Serial ATA Connectors
Connect one end of the Serial ATA cable to a Serial ATA connector
and the other end to your Serial ATA device.
BIOS Setting
Configure the onboard Serial ATA in the Integrated Peripherals
submenu (“OnChip IDE Device” section) of the BIOS. Refer to chap-
ter 3 for more information.
Configuring RAID
The system board allows configuring RAID on Serial ATA drives.
Refer to chapter 5 for steps in configuring RAID.
SATA 0 GND TXP TXN GND RXN RXP GND
1 7
SATA 3
SATA 1
SATA 2
GND
TXP TXN GND RXN RXP
GND
1 7
SATA 0/1
SATA 2/3