DFI EL330-DR - Manual (Page 33)

33
2
Hardware Installation
1 W
The VGA port is used for connecting a VGA monitor. Connect the
monitor’s 15-pin D-shell cable connector to the VGA port
. After you
plug the monitor’s cable connector into the VGA port, gently tighten
the cable screws to hold the connector in place.
BIOS Setting
Configure the onboard VGA in the Advanced Chipset Features
submenu of the BIOS. Refer to chapter 3 for more information.
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.
VGA Port
VGA