DFI EL330-DR - Manual (Page 42)

42
2
Hardware Installation
1
X
Floppy Disk Drive Connector
The floppy disk drive connector supports a standard floppy disk
drive. The floppy cable can be inserted into this connector only if pin
1 of the cable is aligned with pin 1 of this connector.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the floppy
connector on the system board and the other end-most connector
to the floppy drive. The colored edge of the daisy chained ribbon
cable should align with pin 1 of the floppy connector.
BIOS Setting
Enable or disable this function in the Integrated Peripherals submenu
(“Super IO Device” section) of the BIOS. Refer to chapter 3 for
more information.
1
3 3 3 4
2