DFI EL330-DR - Manual (Page 34)

34
2
Hardware Installation
1
Universal Serial Bus Connectors
The system board supports 8 USB 2.0/1.1 ports. USB allows data
exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The USB 4-7 connectors allow you to connect 4 additional USB 2.0/
1.1 ports. The USB ports may be mounted on a card-edge bracket.
Install the card-edge bracket to an available slot at the rear of the
system chassis then insert the USB por t cables to these USB
connectors.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu
(“USB Device Setting” section) of the BIOS. Refer to chapter 3 for
more information.
USB 3
USB 2
USB 1
USB 0
USB 6-7
USB 4-5
1
VCC -Data
+Data
GND
Key
VCC -Data +Data GND N.
C
.
2 1 0
9
W
W