Digital Audio Labs PowerShape 2.1 - Manual (Page 29)

System / configuration controls.
load preset (valid for set only): lprs
The value is the factory or user preset number from which a saved configuration will be loaded into the amplifier.
The preset number is an unsigned integer value, and is between 1 and 4 for user presets or between 11 and 13 for
factory presets.
1 = load configuration from user preset #1
2 = load configuration from user preset #2
3 = load configuration from user preset #3
4 = load configuration from user preset #4
11 = load configuration from factory preset #1 (2.0 stereo)
12 = load configuration from factory preset #2 (3.0 monaural)
13 = load configuration from factory preset #3 (2.1 stereo)
Examples:
=slprs:2! load configuration from user preset #2
=slprs:11! load configuration from factory preset #1 (2.0 stereo)
save preset (valid for set only): sprs
The value is the user preset number into which the current configuration will be stored. The user preset number is an
unsigned integer between 1 and 4.
1 = save current configuration as user preset #1
2 = save current configuration as user preset #2
3 = save current configuration as user preset #3
4 = save current configuration as user preset #4
Example:
=ssprs:1! save current configuration as user preset #1
reboot amplifier (valid for set only): reboot
This command reboots the amplifier. The value is always 1. This command can be used to reboot the amplifier after
changing the serial port or network configuration, causing the new serial or network settings to be used.
Example:
=sreboot:1! reboot amplifier
get or set sleep delay time: sleepdly
The value is the delay time, in minutes, after which the amplifier will go into “sleep” mode if the audio level remains
below the sleep threshold. The value is an unsigned integer between 0 and 120. A delay time of 0 disables sleep
mode.
Examples:
=ssleepdly:10! set sleep delay to 10 minutes
=ssleepdly:0! disable sleep mode
! ! ! ! ! ! ! ! ! ! ! ! 29