Digital Audio Labs PowerShape 2.1 - Manual (Page 30)

get or set sleep threshold: sleepthr
The value is the audio level below which the amplifier will be considered “idle”. When idle, the amplifier will be put
into “sleep” mode after the specified delay time. The value is a signed integer between -80 and -30 (-80.0 dBFS to
-30.0 dBFS).
Examples:
=ssleepthr:-60! set sleep threshold to -60 dBFS
=ssleepthr:-48! set sleep threshold to -48 dBFS
get or set serial port baud rate: serbaud
The value indicates the baud rate at which the RS-232 serial port will operate. The value is an unsigned integer, and
must be one of the following standard baud rate values. Changes to the serial port baud rate take effect the next time
the amplifier is powered on or rebooted.
1200 19200
2400 38400
4800 57600
9600 115200
Examples:
=sserbaud:9600! set serial port baud rate to 9600 baud
=sserbaud:115200! set serial port baud rate to 115200 baud
get or set serial port data format: serfmt
The value indicates the data format that will be used on the RS-232 serial port. The value is a 3-character 7-bit
ASCII string, and must be one of the following values. Changes to the serial port data format take effect the next
time the amplifier is powered on or rebooted.
8N1 = 8 data bits, no parity, 1 stop bit
8N2 = 8 data bits, no parity, 2 stop bits
7E1 = 7 data bits, even parity, 1 stop bit
7E2 = 7 data bits, even parity, 2 stop bits
7O1 = 7 data bits, odd parity, 1 stop bit
7O2 = 7 data bits, odd parity, 2 stop bits
Examples:
=sserfmt:7E1! set serial port data format to 7 data bits, even parity, 1 stop bit
=sserfmt:8N1! set serial port data format to 8 data bits, no parity, 1 stop bit
get or set network port IP address: netip
The value is the IP address to be used by the network port. A valid IP address (e.g., 10.1.2.3) selects static IP address
assignment. A value of 0.0.0.0 selects dynamic IP address assignment using DHCP, BOOTP or AutoIP. Changes to
the network port IP address take effect the next time the amplifier is powered on or rebooted.
Examples:
=snetip:10.1.35.108! set static IP address to 10.1.35.108
=snetip:0.0.0.0! select dynamic IP assignment
! ! ! ! ! ! ! ! ! ! ! ! 30