DR Power Walk-behind 12.5 HP Tecumseh with 42 Lawn Deck - Manual (Page 25)

CONTACT US AT www.DRPower.com or CALL TOLL FREE 1-800-DR-OWNER 21
Figure 9 Figure 10
Engaging the Blades
1. Squeeze the Operator Presence Lever against the Handlebar Grip (Figure 9).
2. Engage the Blades by pulling UP on the Blade Engage Knob (Figure 10).
NOTE: If you pull UP on the Blade Engage Knob before holding down the Operator Presence Lever, the
Engine will shut off.
ALWAYS DISENGAGE THE BLADES OF THE DR WIDE-CUT LAWN MOWER BEFORE SHIFTING INTO
REVERSE.
Stopping the Blades
Stop the Blades by pushing DOWN on the Blade Engage/Disengage Switch Knob (Figure 10).
NOTE: If you release the Operator Presence Lever with the Blades engaged, the Engine will shut off.
Stopping the Engine
1. Disengage the Blades by pushing DOWN on the Blade Engage/Disengage Switch Knob (Figure 10).
2. Set the Parking Brake by squeezing the Lever and lifting up on the Lock pin.
3. Move the Shift Lever to the N (Neutral) position.
4. Move the Throttle Control to the IDLE position.
5. Turn the Key to the OFF position and remove it for safety.
NOTE: Also close the Fuel Shut-Off Valve when transporting or storing the Mower.
Operator Presence Lever
Blade Engage/Disengage Switch Knob
Wheel Clutch Lever