DR Power Walk-behind 12.5 HP Tecumseh with 42 Lawn Deck - Manual (Page 26)

22 DR
®
WIDE-CUT LAWN MOWER
Figure 11
Adjusting the Cutting Height
ALWAYS DISENGAGE THE BLADES OF THE DR WIDE-CUT LAWN MOWER BEFORE ADJUSTING THE
CUTTING HEIGHT.
You can adjust the cutting height in 1/2" increments by repositioning the Cutting Height Adjustment Lever on
the right side of the Lawn Deck (Figure 11). Your DR WIDE-CUT LAWN MOWER is fitted with a Clevis Pin to
prevent accidental dislodging of the Cutting Height Adjustment Lever over rough terrain. To change height
settings, remove the Clevis Pin and re-position the Cutting Height Adjustment Lever to the desired cutting
height (Figure 11). After adjusting to a new height, re-insert the Clevis Pin on the appropriate side of the
Adjustment Lever in the new position (Figure 11).
Clevis Pin
Cutting Height
Adjustment Lever
Clevis Pin location for Cutting
Heights 2", 3" and 4". Clevis Pin location for Cutting
Heights 2.5", 3.5" and 4.5".