DR Power Walk-behind 12.5 HP Tecumseh with 42 Lawn Deck - Manual (Page 41)

CONTACT US AT www.DRPower.com or CALL TOLL FREE 1-800-DR-OWNER 37
Removing the Wheels
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION, STOP THE ENGINE AND WAIT
FIVE (5) MINUTES TO ALLOW ALL PARTS TO COOL. DISCONNECT THE SPARK PLUG WIRE, KEEPING IT
AWAY FROM THE SPARK PLUG.
Tool Needed:
•
3/4" socket with extension
1. Loosen the Wheel Nuts a couple of turns with
the Wheel on the ground.
2. Block the machine so the Wheel you are
removing is off the ground.
3. Remove the three (3) Nuts and slide the Wheel
off (Figure 31).
4. Replace the Wheel and finger-tighten the Wheel
Nuts before unblocking the machine.
5. Tighten the Wheel Nuts with the Wheel resting
on the ground.
Adjusting the Parking Brake
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION, STOP THE ENGINE AND WAIT
FIVE (5) MINUTES TO ALLOW ALL PARTS TO COOL. DISCONNECT THE SPARK PLUG WIRE, KEEPING IT
AWAY FROM THE SPARK PLUG.
Tool Needed:
•
1/2" Open End Wrench
To adjust the Parking Brake, tighten or loosen the Nut
shown in Figure 32. Tightening the Nut (clockwise) will
increase pressure and loosening the Nut
(counterclockwise) will decrease the pressure on the
Brake Pad.
Parking Brake
Adjust Nut
Wheel Nuts
Figure 31
Figure 32