DR Power Tow-Behind 8.00 Premier (Pre-August 2010) - Manual (Page 18)

14 DR
®
PREMIER LEAF and LAWN VACUUM
4. Remove the Collector Box Cover and open half of the opposite side of the Carton, being sure to fold
down only one half of the side.
5. Remove the Side, Bottom, Front & Rear Panels, and the Tilt Bed from the Carton.
6. Remove the Adapter and Parts Boxes.
7. Locate the Hitch Kit (if provided) and the Plastic Bag containing the Assembly Hardware inside the
Small Parts Box.
WEAR EYE PROTECTION WHEN CUTTING THE BANDS. THE BANDING MAY HAVE A LOT OF TENSION
ON IT AND MAY SNAP AND CUT YOU. ALWAYS STAND TO ONE SIDE WHEN CUTTING THE BANDS.
8. Stand to one side and cut the Pallet Strapping holding the machine to the Pallet.
9. Cut the Wire Ties and reposition the Engine Blower Assembly on the Trailer Frame (Figure 2 on page
13). Reinstall with four (4) sets of Hand Knobs, Washers, and Lock Washers. Two (2) sets are in the
Plastic Parts Bag and two (2) sets held the Engine in the shipping position.
Tip: Two people can move the Engine Mount easily.
10. Straighten the Wheels, lift the Tongue of the Trailer, and roll the machine from the shipping pallet.
Tip: An extra person would be helpful to guide the machine when rolling it from the shipping Pallet
using the “wheelbarrow” method. See below.
11. For Electric Start models, a set of Ignition Switch Keys is temporarily located on the Battery Bracket
by means of a plastic tie. See below. Cut the tie to remove the Keys.
12. Save your Pallet and Packaging Material until you are fully satisfied with your machine.
Tire Pressure Check
The maximum Tire pressure is marked on the side of each Tire. Do not exceed the manufacturer’s
recommended maximum pressure.
Push in this Direction
Location of the Keys