DR Power 8.25 Pro Power Wagon (February 2007 - February 2009) User Manual
Page 36
Advertising
32 DR
®
POWERWAGON-PRO
Figure 29
Removing and Replacing the Stake Body or Molded Body
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, SET THE
PARKING BRAKE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK
PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.
Tools Needed:
•
(2) 1/2" Open-End or Box Wrenches
1. Position the machine on a level surface and set the Parking Brake.
2. Tip the Bed forward.
3. Remove the four (4) sets of Nuts and Bolts securing the Body
(Figure 29).
NOTE: The 4th set of
Nuts
& Bolts is
hidden.
Nuts
& Bolts to remove.
Advertising
This manual is related to the following products: