ESI Audioterminal 010 - Manual (Page 21)

22
1. Output Level Fader/Level Meter
These faders are the output volume control faders that controls 10 outputs of the Audioterminal
010.
10 outputs consist of 5 Stereo channels and you can adjust 8 Multi channels and SPDIF 2 channel.
Each faders act the same so you need to learn only one.
a. MUTE – Channel Mute button
Press these buttons to mutes the selected channel. When you press middle of this button, 2
channels become muted. If you press left or right of this button, selected channel becomes muted.
* This function only works when the Master Fader selected as ‘MAIN’.
b. SOLO – Channel SOLO Button
Press these buttons to output only the sound of a selected channel. When you press middle of this
button, 2 channels become muted. If you press left or right of this button, selected channels
becomes SOLO mode.
* This function only works when the Master Mixer Fader selected as ‘MAIN’.
c. Level Fader
Level Faders would change the level of the output volume. Each fader consists of stereo pairs.
However, you can control outputs individually or stereo pairs. You need to move the mouse
pointer over the specific port fader to adjust it individually or move the mouse pointer over the
middle of the two ports to adjust it as a stereo channel. If the port fader is selected, it will turn
into a brighter color.
You can move the fader in three different ways. Basically, the volume level can be adjusted by
±1.5dB.
- Drag the fader as you press the left mouse button.
- Select the fader with the mouse cursor and adjust with the mouse wheel. You can
select the steps from the pull down menu, ‘Config’ -> ‘Mouse Wheel’
- Select the fader with the mouse cursor and use the up and down arrows of your
keyboard.
* This function only works when the Master Mixer Fader selected as ‘MAIN’.