ESI Audioterminal 010 - Manual (Page 24)

25
4. Pull Down Menu
The Audioterminal 010 control panel includes a pull down menu bar that contains the
configuration for the Control Panel.
1. File - Exit
File – Exit will close the Audioterminal 010 Control Panel window but it will not shut down the Control
Panel. You can launch the Control Panel by clicking on the Audioterminal 010 icon in the system tray.
2. Config – Mouse Wheel
The Config –Mouse Wheel will control the mouse wheel adjustment. When you use the mouse wheel to
adjust the volume level, the adjustment step is set to ±1.5dB. You can configure the adjustment steps to
your preference.
- Step 1 : When you move the mouse wheel one step, the fader will move by ±1.5dB.
- Step 2 : When you move the mouse wheel one step, the fader will move by ±3.0dB.
- Step 4 : When you move the mouse wheel one step, the fader will move by ±6.0dB.
- Step 8 : When you move the mouse wheel one step, the fader will move by ±12.0dB.
3. Config – Latency
This will decide the latency of the Audioterminal 010. The Audioterminal 010 provides 7 different
sample buffer size; 48 sample ~2048 sample.
You must close your applications before change latency.
In case of Sonar, after change latency you need to click ‘Wave profiler’ again.
If the latency is changed, all your applications will be affected.
4. Config – Factory Default
This returns all the Audioterminal 010 configurations to their default setting.
5. Config - Always On Top
This will set the Audioterminal 010 control panel to always over other Windows. If this is not
selected, the active windows will be set over the Audio terminal 010 Control Panel.
7. Mapper
In case of using Direct Sound or MME driver, you can make selected 2 channel from 10 output
port of the Audioterminal 010 to stereo out. Driver device’s name is ‘AT010 STEREO Wave’. You
need to set it up in Multimedia Setup or system setup of applications and you can select Multi