Installation (cont.) – Fire Magic 3049 Aurora Infrared Burner Kit Installation User Manual

Page 2

Advertising
background image

REV 3 - 1302260945

L-C2-280

2

5. The grill is equipped with a heatshield kit for each main burner.

This kit is only functional with the standard main burner, and
must be removed for proper infrared burner operation. Use pliers
to remove the diverter tube by bending in each side and pulling
it outwards (see Fig. 2-1), then reach in and remove the silicone
gasket (see Fig. 2-2).

6. Pull out and completely remove the drip tray from the grill.

7. With the burner valves in the OFF position, pull the valve knobs

from their stems. Use a Phillips screwdriver to remove the control
panel fastener screws on either side of the grill control panel (see
Fig. 2-3). Release the control panel by lifting it slightly and remove
it from the grill. Make sure to retain the screws and fi nish washers
for re-attaching the control panel.

Note: To protect the wiring harness, carefully lift the control panel

away from the frame and let it rest on the attached chain.

8. Lift the heat shield up and inward slightly to clear the diagonal slots

hooked over the oven fi re wall then pull away from the manifold
(see Fig. 2-4).

9. Remove the existing ignitor wire by fi rst sliding the rubber sleeve

back off the ignitor, then pulling the wire to detach from the ignitor.
Next remove the ignitor nut on the control panel side of the fi re wall
with a 9/16 open-end wrench (see Fig. 2-4) and remove the ignitor
box from inside the oven. Remove the rubber sleeve from the wire
and pull the wire through the heat shield and the insulating tube
in the manifold fi re wall. Disconnect the other end of the ignitor
wire from the ignitor module (see Fig. 2-5).

Control panel

Valve

stem

Screw

Fig. 2-3 Remove control panel

Fig. 2-2 Remove silicone gasket

Remove gasket

Fig. 2-1 Remove diverter tube

Use plier

s to remo

ve

Diverter tube

Bend sides

inward

Fig. 2-4 Remove heat shield and old ignitor

Old ignitor

Heat shield

Fig. 2-5 Remove old ignitor wire

Remove wire from

ignitor module

INSTALLATION (cont.)

Advertising
This manual is related to the following products: