Flowserve PHL - Manual (Page 30)

PHL USER INSTRUCTIONS ENGLISH 00079593 – 10/10
Page 30 of 31
8.2 Typical Parts list
For P.O. related parts list see table on page 29.
8.3 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be
sent to the Purchaser separately unless the
contract specifically calls for these to be included
into the User Instructions. If required, copies of
other drawings sent separately to the Purchaser
should be obtained from the Purchaser and
retained with these User Instructions.
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these Instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instructions
Supplementary instructions such as for a driver,
instrumentation, controller, seals, sealant system
etc are provided as separate documents in their
original format. If further copies of these are
required they should be obtained from the supplier
for retention with these User Instructions.
10.2 Change notes
If any changes, agreed with Flowserve Pump
Division, are made to the product after its supply, a
record of the details should be maintained with
these User Instructions.
10.3 Additional sources of information
Reference 1:
API 610, 9
th
edition / ISO 13709, January 2003
Reference 2:
NPSH for Rotordynamic Pumps: a reference guide,
Europump Guide No. 1, Europump & World
Pumps, Elsevier Science, United Kingdom, 1999.
Reference 3:
Pumping Manual, 9
th
edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom,
1995.
Reference 4:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 5:
ANSI/HI 1.1-1.5
Centrifugal Pumps - Nomenclature, Definitions,
Application and Operation.
Reference 6:
ANSI B31.3 - Process Piping.
Reference 7:
Europump Terminology standard