Flowserve 2000 Series Digital Positioner - Manual (Page 24)

Table XIII: 316 Stainless Steel Tubing
Description Number
Pressure sensor wire tubing (0.50-inch diameter 0.035-inch thick) 10045503
Temperature extended wet leg tubing (0.50-inch diameter 0.065-inch thick) 10055784
I/P wire and thermocouple tubing ( 3 /
8
-inch diameter, 0.035-inch thick) 10013367
On remote mount pressure sensor configurations, the wet-leg tubing must have a wall thickness of 0.065-inch.
1. Two-pin connector
2. Temperature probe
3. Tubing, 0.035 wall, (see Table XIII)
4. Swagelock tube fitting 5. Stainless steel pipe
6. Adapter fitting
7. Adapter fitting
14. Explosion-proof union
Figure 19: StarPac Temperature Sensor, Flush-mount Version
1
2 3
4
1
5
14 6
2
7
Temperature probe boss
Div II Configuration
Div I Configuration
Flowserve Corporation has established industry leadership in the design and manufacture of its products. When properly selected, this Flowserve product is designed to perform its
intended function safely during its useful life. However, the purchaser or user of Flowserve products should be aware that Flowserve products might be used in numerous applications
under a wide variety of industrial service conditions. Although Flowserve can (and often does) provide general guidelines, it cannot provide specific data and warnings for all possible
applications. The purchaser/user must therefore assume the ultimate responsibility for the proper sizing and selection, installation, operation and maintenance of Flowserve products.
The purchaser/user should read and understand the Installation Operation Maintenance (IOM) instructions included with the product, and train its employees and contractors in the safe
use of Flowserve products in connection with the specific application.
While the information and specifications presented in this literature are believed to be accurate, they are supplied for informative purposes only and should not be considered certified or
as a guarantee of satisfactory results by reliance thereon. Nothing contained herein is to be construed as a warranty or guarantee, express or implied, regarding any matter with respect
to this product. Because Flowserve is continually improving and upgrading its product design, the specifications, dimensions and information contained herein are subject to change
without notice. Should any question arise concerning these provisions, the purchaser/user should contact Flowserve Corporation at any of its worldwide operations or offices.
For more information, contact:
For more information about Flowserve, contact www.flowserve.com or call USA 972 443 6500
Regional Headquarters
1350 N. Mt. Springs Prkwy.
Springville, UT 84663
Phone 801 489 8611
Facsimile 801 489 3719
12 Tuas Avenue 20
Republic of Signapore 638824
Phone (65) 862 3332
Facsimile (65) 862 4940
Flowserve and Valtek are registered trademarks of Flowserve Corporation.
12, av. du Québec, B.P. 645
91965, Courtaboeuf Cedex,
France
Phone (33 1) 60 92 32 51
Facsimile (33 1) 60 92 32 99
Quick Response Centers
5114 Railroad Street
Deer Park, TX 77536 USA
Phone 281 479 9500
Facsimile 281 479 8511
104 Chelsea Parkway
Boothwyn, PA 19061 USA
Phone 610 497 8600
Facsimile 610 497 6680
1300 Parkway View Drive
Pittsburgh, PA 15205 USA
Phone 412 787 8803
Facsimile 412 787 1944
FCD VLAIM042-03 © 2000 Flowserve Corporation. Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611