Flowserve Pulsair III Digital User Manual
Page 25
48
Worcester Controls Pulsair III Digital Electronic Positioner FCD WCAIM2056-00 - 08/04
fl owserve.com
49
Worcester Controls Pulsair III Digital Electronic Positioner FCD WCAIM2056-00 - 08/04
5. Install the cam assembly B on the shaft and push it down to its position. If the board
has microswitches, be careful not to damage the levers.
B
6. Tighten the screws F, on the cam assembly. Do not over tighten the screws. The
cams should be able to move in relation to each other.
F
7. Install the inner cover with the two screws, G.
8. Connect the wiring for the transmitter feedback on the terminal block according to
the drawing on the next page.
G
9. Adjust the position where the switches/sensors should be affected by turning the
cams with a screwdriver.
10. Tighten the cam assembly screws F when the cams are correctly adjusted.
11. Install the indicator and cover. To calibrate the feedback transmitter, see the drawing
on the next page.
F