Formax FD 150 - Manual (Page 18)

Operating Manual
14 1/97
Figure 4.1 -- FD 150 Power Connection
4.3 Line Fuses
The FUSE DRAWER, located on the input end, contains
two LINE FUSES. (Refer to Figure 4.1.) The neutral and
hot lines of power are fused. Both LINE FUSES must be in
place for the FD 150 to operate properly.
CAUTION
VERIFY THAT THE LINE FUSE VALUE IS
CORRECT FOR THE VOLTAGE SETTING.
UNPLUG THE
FD 150 BEFORE STARTING THIS
PROCEDURE.
Use the following instructions to verify that the installed
LINE FUSES have the proper fuse value:
1. Unplug the POWER CORD.
2. Use a small screwdriver or similar tool to push up on
and release the FUSE DRAWER LOCKING TAB.
3. Pull the FUSE DRAWER out of the POWER ENTRY
CASING. The attached LINE FUSES are inside.