Formax FD 150 - Manual (Page 45)

Operating Manual
1/97 41
8.1.3 Imprint Is Too Light
Replace the INK ROLL if the imprint does not improve
after turning the INK ADJUSTMENT KNOB. The INK
ROLL also needs to be replaced if you hear the COVER
knocking. Refer to Figure 8.1 throughout this procedure.
Figure 8.1 -- Ink Roll Installation
NOTE
Before replacing the used INK ROLL, put on the
gloves provided with the new INK ROLL.
1. Open the COVER.
2. Pull out the COTTER PIN.
3. Hold the INK ROLL currently installed in the FD 150.
4. Pull out the AXLE.
5. Discard the used INK ROLL.
6. Hold the new INK ROLL between the sides of the INK
ROLL CARRIAGE.
7. Insert the AXLE, pointed end first, through the holes in
the INK ROLL CARRIAGE.
8. Insert the straight side of the COTTER PIN into the
hole in the pointed end of the AXLE.