FSR FLH20-1-BX - Manual (Page 2)

1-GANG/2-GANG CONFIGURATION
(2-GANG/1-GANG ALSO POSSIBLE)
2-GANG/2-GANG CONFIGURATION
3-GANG/1-GANG CONFIGURATION
(1-GANG/3-GANG ALSO POSSIBLE)
4-GANG CONFIGURATION
IF INSTALLING "JUNCTION BOX/ABANDONMENT" COVER, USE
THAT COVER'S INSTALLATION GUIDE, AND IGNORE THE REMAINDER
OF THESE INSTALLATION INSTRUCTIONS.
NOTE
GANG MOUNTING BRACKET
(2) DIVIDER HOLDER
OPTIONAL
DIVIDER
COVER
PLATE
GANG MOUNTING
BRACKET
DIVIDER
HOLDER
OPTIONAL
DIVIDER
GANG MOUNTING
BRACKET
DIVIDER
HOLDER
OPTIONAL
DIVIDER
GANG MOUNTING
BRACKET
(2) DIVIDER HOLDER
(NO DIVIDERS USED!)
GANG DIVIDER ASSEMBLY
87.5
cu. in.
94
cu. in.
87.5
cu. in.
94
cu. in.
117.5
cu. in.
64
cu. in.
183.3
cu. in.
CUTAWAY FOR
CLARITY ONLY
DIVIDER HOLDER:
INSTALL WITH #8-32
FLAT HEAD SCREW
TO GANG MOUNTING
BRACKET
OPTIONAL
DIVIDER
COVER PLATE:
INSTALL WITH #6-32
PAN HEAD SCREW TO
GANG MOUNTING
BRACKET
INSTALLED
ELECTRONIC
COMPONENT
GANG
MOUNTING
BRACKET
INSTALLING ELECTRONIC COMPONENTS
PULL WIRES AND CABLES TO BOX AS NECCESSARY (REMOVAL OF
GANG MOUNTING BRACKETS MAY BE REQUIRED). TERMINATE
WIRES AND CABLES TO ELECTRONIC COMPONENTS, AND INSTALL
ELECTRONIC COMPONENTS ONTO GANG MOUNTING BRACKETS.
PLACE THIS INSTALLATION GUIDE BACK IN BOX AND REINSTALL
TEMPORARY COVER IF FINISHED COVER IS TO BE INSTALLED AT
A LATER DATE.
COVER RIM INSTALLATION
REMOVE AND DISCARD TEMPORARY COVER AND SCREWS.
REMOVE COVER ASSEMBLY FROM RIM (SEE DETAILS 1 THRU 3),
SET REMOVED COVER (WITH SMALL DOORS) ASIDE. APPLY A
CONTINUOUS 1/4" BEAD OF RTV SILICONE TO THE INSIDE CORNER
OF ALL 4 SIDES OF THE CONCRETE-STOP FLANGE ON THE BOX
(SEE RTV SILICONE PLACEMENT DETAIL). QUICKLY INSTALL RIM
ONTO BOX WITH PROVIDED #8-32 x 1/4" FLAT HEAD PHILLIPS
SCREWS.
RIM
COVER ASSEMBLY
DETAIL 1
LIFT LATCH HANDLE 90°
DETAIL 2
ROTATING LATCH HANDLE 45° CLOCKWISE
ALLOWS COVER TO BE REMOVED FROM RIM
DETAIL 3
ROTATING LATCH HANDLE 90° CLOCKWISE
ALLOWS SMALL DOOR TO BE REMOVED
FROM COVER
APPLY A CONTINUOUS 1/4" BEAD
OF RTV SILICONE TO ALL 4 SIDES
(10) #8-32 FLAT HEAD SCREW RIM CONTINUOUS
1/4" BEAD OF
RTV SILICONE
PER CUSTOMER SPECIFICATIONS, CONFIGURE GANG MOUNTING BRACKETS AS SHOWN BELOW AND
REASSEMBLE INTO BOX (DECORA WALL PLATES SHOWN AS REFERENCE AND NOT INCLUDED).
GANG MOUNTING BRACKET CONFIGURATION
LATCH OPERATION
CONCRETE FLOOR
RTV SILICONE PLACEMENT DETAIL
(2) #8-32 PAN HEAD SCREW