Fulgor Milano CCM 4509 TC - Manual (Page 28)

28 29
GB
button.
The procedure for programming the quantity of coffee,
and other beverages, in the cup is as follows:
• press the coffee key for 5 seconds until the LED
flashes.
• press the START/STOP key to start dispensing. The
two LEDs flash for its duration.
• press the START/STOP button again when the
desired quantity is reached.
Restoring the factory settings
When it leaves the factory, the machine is calibrated
for Italian-style espresso coffee and German-style
stretched coffee.
• If you need to restore these standard values, you
must place the machine in standby and press the
coffee regulation button for 6 seconds.
• You will see all the LEDs, except on/off, flash for 5
seconds; after that time, the board has stored the
default values.
• Press the on button and the selections will now use
the factory values.
The standard values are only relative to the
quantity of water necessary for each single
dose.
FOR EXPERT USERS ONLY:
PROGRAMMING THE GRINDING TIME
The grinding time for strong coffee is programmable and
medium and light coffee are calibrated accordingly.
To enter programming mode, when the machine is in
standby mode:
• press the START/STOP button for 5 seconds; the
LED s on the upper left line light up to indicate the
grinding time;
• to increase the time, press the coffee regulation
button and to, decrease it, the START/STOP button.
At the end of the operation, just press the on/off
button to exit and confirm the changes.
Automatic adjustment of coffee quantity.
If the quantity of coffee has been wrongly adjusted, so
as not to allow coffee dispensing, the machine is able
to perform a series of automatic checks, until the right
quantity of coffee and therefore correct dispensing is
achieved.
Automatically and without any intervention by the
machine operator, the machine will start grinding the
coffee (indicated by a number of flashes of the “generic
alarm” symbol) and will try and dispense coffee.
The procedure terminates when the coffee is dispensed
and consequently the new coffee quantity parameters
are stored.
A request could be made to perform a washing
operation. If so, perform washing as described in
chapter 7. Afterwards, make a cup of coffee. If the
machine starts grinding coffee again automatically and
without the intervention of the operator, switch it off and
call in the after-sales service.
12. PROGRAMMING THE QUANTITY OF
COFFEE IN THE CUP
All the cycles have a preset quantity, except for water
and steam.
The machine is already calibrated at the factory to
dispense the ideal quantity of coffee for an espresso
cup.
While dispensing the beverage, you can stop dispensing
before the preset time by pressing the START/STOP