GAI-Tronics 234L(x)-xxx LITE Series Stanchions - Manual (Page 13)

Pub. 42004-393B
Model 234L(x)-xxx LITE Series Stanchion Page: 12 of 18
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-393b.doc
03/07
5. Reattach the internal mounting bracket. Route the incoming power wires through the access slot on
the bracket. Use the two screws that were removed previously to reattach the bracket.
6. Slide the stanchion body over the upper lip of mounting plate at an angle that allows the support bar
of the main body to slide into the top lip of the mounting plate. Rotate the main body parallel to the
support surface, allowing the bottom lip of the mounting plate to insert into the stanchion body. Refer
to Figure 8. Do not attach the bottom attachment screws until after telephone installation and final
test.
Figure 8. Assemble Stanchion