GAI-Tronics 300 Series RED ALERT Emergency Telephone Manual - Manual (Page 29)

P UB . 42004-438K
300 S ERIES E MERGENCY T ELEPHONE M ANUAL P AGE
27 of 45
f:\standard ioms - current release\42004 instr. manuals\42004-438k.doc
01/15
SMART Mode
Using a touch-tone telephone, call the emergency telephone and listen for a confirmation tone during
ringing, indicating the telephone has answered.
1. Press “***” to enter the programming mode.
2. Wait 2 seconds.
3. Enter **0000 (0000 is the factory default maintenance PIN number).
4. Enter *20. If the RED ALERT ® Telephone has successfully entered into the maintenance mode, it
will respond with six DTMF tones. If access has been denied, it will respond with two DTMF tones.
If this occurs, repeat steps 3 and 4.
5. Press “*8321” and after hearing a short beep, begin speaking.
6. Press “*” when recording has been completed.
7. The recording will automatically play back when the “*” DTMF code is pressed.
Voice Annunciation Activation
Steps for activating the Voice Annunciation message are:
1. The RED ALERT ® Emergency Telephone user presses the HELP push button to autodial a
preprogrammed number.
2. Upon answering or any time during the two-way conversation, the called party can activate the Voice
Annunciation message by pressing “00” on the telephone keypad.
3. The Voice Annunciation message is transmitted over the telephone line to be heard by the called
party and it is broadcasted over the RED ALERT ® Telephone’s integral speaker.
4. Upon completion of the recorded message, two-way communications may continue.
5. Pressing “00” again will cause the Voice Annunciation message to replay.