GAI-Tronics 393-001AD, RED ALERT Auto-dial Telephones - Manual (Page 13)

P UB . 42004-472B
A UTO -D IAL T ELEPHONE M ANUAL P AGE
11 of 33
f:\standard ioms - current release\42004 instr. manuals\42004-472b.doc
01/15
5. Connect the telephone’s modular plug to a USOC RJ11 or CA11A (Canada) modular connector or (if
applicable) the telephone line suppressor. An inline coupler is provided for use, if necessary. Refer
to Figure 9 for mounting details and Figure 11 for component locations.
6. Allow the telephone a minimum of 35 seconds to initialize.
7. Using the “Setup” section of this manual,
 Configure the hardware as required. Refer to the “Hardware Configuration” section on page 14
for details.
 Adjust the audio levels, if necessary. Refer to Figure 11 for “Speaker Volume” and “Microphone
Sensitivity” potentiometer locations.
 Perform the initial programming. Refer to the “Standard Mode Programming” section on page 20.
7. Verify operation by calling to and from another telephone.
8. Complete the installation by attaching the front panel assembly to the rear enclosure mounting flanges
using the six supplied #10-32 security screws and washers, 10–12 in-lbs. of torque recommended.